Making the loops


 . 

To produce a model that is about eight inches long, a convenient size for the loops is 10mm wide, 87mm long with a 6mm tab for glueing. You will need about four sheets for each dog. Make a start by marking out 1cm points across a standard A4 sheet and join them up


You will need a lot of these loops so be prepared for a quite a bit of marking out, cutting and glueing.







Turn the card lengthwise and mark out for three lots of 87mm plus 6mm as shown.  I have made a template to make this quicker and consistent.
cut across the sheet as shown then start cutting the strips leaving the marked glueing tab on each one. keep the scrap piece from the end to make some ears from later or even two more strips..


 Now you should have a nice pile of strips so they need to be folded double to the 87mm mark leaving the 6mm bit to fold down to be glued. Once you get going it does not take so long and I tend to do one lot of 21 strips at a time, glue them and then do some weaving with them.
 I use a glue stick as they are quick to use and not messy. If you smear both faces with it they seem to bond really well. when you have a nice pile of finished loops you can make a start putting them together..